POWER CORD 3.9 FT.
CENTER OF HOLE 18-1/2" (470 mm) LIP OF BOWL 5-1/2" (140 mm) CENTERS OF SEAT MOUNTING BOLT HOLES 8" Min. (203 mm) EDGE OF FLAT BOWL SURFACE CENTER OF TOILET FRONT OF TANK CENTER OF HOLE 2" Min. (50 mm)
WASHLET INSTALLATION REQUIREMENTS
When your existing toilet is in need of an upgrade.
ELONGATED FRONT WASHLET
Elongated seats approximately 18-1/2 inches (470 mm) from mounting holes to front of bowl. The following four-part diagram details the approximate measurements and requirements for installing most WASHLET models on existing toilets. Note that some styles of toilets may not allow the WASHLET to fit properly due to certain contours where the tank meets the bowl. Minimum of 2 inches (50 mm) from front face of tank to the center of mounting holes. Minimum of 8 inches (203 mm) of open space from center of toilet to edge of flat bowl surface. Approximately 5-1/2 inches (140 mm) from the centers of the seat mounting holes.
1. 2. 4. 3.
WASHLET BROCHURE
26
Previous Page